REINCARNATION'S MINIMUM BUILD SPECS

 

 

Below is a list of the guaranteed minimum work on each build :

- FULL DISASSEMBLY OF THE DONOR BIKE AND THOROUGH INSPECTION

- FRAME MODIFICATIONS AND WELDING

  • Tail hoop for chosen seat
  • Removing unused tabs, pins and holders
  • Electronics tray
  • LED tail light integration if needed

- ENGINE WORK

  • Compression & leak Test
  • Piston Rings and cylinder sleeves replaced if needed
  • Gaskets replaced
  • Oil screen cleaned
  • Timing chain adjusted
  • Valve clearances checked and adjusted
  • Soda blasted & enameled to color of choice

- SANDBLASTING AND POWDER-COATING

  • Frame
  • Rear swingarm
  • Wheels & srocket hub
  • Lower forks
  • Top and bottom triple tree
  • Rearsets
  • Clutch and starter cover

- CARBURETOR WORK

  • Disassembled, soda blasted, and ultrasonic cleaned
  • Gaskets, jets, floats, drains, and accelerator pump replaced
  • Filters or velocity stacks
  • Fuel/Air adjusted & synched

- SUSPENSION

  • Fork interior cleaned & seal seat surfaces polished
  • Fork seals & dust caps replaced
  • Rear Suspension replaced
  • Acorn nuts replaced
  • suspension adjusted to rider

- ELECTRICAL

  • Battery & fuse box replaced
  • Stator & grounding cables replaced and rerouted
  • Left and right controls cleaned/lubricated or replaced
  • Ignition replaced & relocated
  • Starter & flashing relays Replaced
  • Headlight, housing, and brackets replaced
  • LED taillight & turn signals
  • Wiring inspected and rerouted
  • Spark plug boots & wire
  • Analog speedometer

- FUEL SYSTEM

  • Petcock, fuel filter, and fuel lines replaced
  • Tank cap and hardware sand blasted and painted
  • Fuel tank inspected and cleaned
  • custom monotone paint job on tank with new emblems
  • new gas cap hardware for tank

- BRAKE SYSTEM

  • Braided brake lines, brake pads & hardware
  • caliper inside polished, seals replaced
  • Brake rotors resurfaced or replaced
  • Master cylinder rebuilt

- EXHAUST

  • Exhaust headers polished or Re-enameled
  • Exhaust header wrapped if customer prefers
  • Exhaust muffler tip & gaskets replaced

- BEARING AND BUSHING REPLACEMENT

  • Head bearings & races replaced
  • Wheel bearings replaced
  • Sprocket hub inspected / replaced
  • Rear suspension upper bushing
  • Swingarm lower suspension bushing

- FINAL TESTING AND QUALITY ASSURANCE

  • Torque specs checked
  • Bike & engine road tested for at least 200 miles
  • Torque specs re-checked
  • Electrical and suspension tolerances are checked and adjusted
  • Photo shoot of bike for records during the entire build process